Mesa/Boogie Mark Five Owner's Manual Page 28

  • Download
  • Add to my manuals
  • Print
  • Page
    / 52
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 27
POWER
This toggle switch delivers the A.C. power to the MARK FIVE: 25. Make sure the amplifier is grounded (all three terminals
of the A.C. power cord connected) to avoid injury to the user as well as to the amplifier. Also make sure the proper voltage (117–125
Volts AC Domestic US Model) is present at the wall socket.
Always follow the Cold Start Procedure described in the STANDBY section when powering up your amplifier. This will
reduce the likelihood of tube problems and increase their musical life.
STANDBY
Perfect for set breaks...this toggle switch also serves an even more important purpose. From Cold-Start, the STANDBY
position allows you to warm up the tubes—especially power tubes— before applying the high voltage to them by switching the Standby
to the “ON” position. Before POWER is switched to “ON” - make sure the STANDBY switch is set in the “STANDBY” position.
Cold-Start Procedure:
Flip the POWER SWITCH to ON, then wait at least 30 seconds for the tube filaments to warm up and then flip the STANDBY switch to
the ON position. This prevents the shock of high voltage hitting cold tubes and reduces the likelihood of tube problems and increases
their toneful life substantially.
NOTE: This Cold Start Procedure is an important part of ensuring maximum tube life and reliability. Like a light bulb, the most wear
occurs in the instant (short period, first few seconds) voltage is first applied. Like a light bulb, if a dimmer is used to reduce the volt-
age for the first few seconds or so of use, increased longevity is the result. The STANDBY is the amp’s equivalent to a dimmer and
using it in the above described method will ensure the longest life and best performance from a set of tubes (especially Output tubes).
That covers the Inputs, Channels, Modes and Controls found on the Front Panel of the MARK FIVE: 25, now let’s swing around to the
Rear Panel and take a look at the Outputs, Features and Controls located there.
PAGE 24
CLEAN
CRUNCH
FS
MK IIC+
MK
IV
XTREME
GAIN TREBLE
MID BOOST
MID PRESENCE MASTERBASS
EQ ON
EQ
O
O
EQ FS
SPKR
ON
CLOSED
BACK
OPEN
BACK
CabClone™
D.I.
SPKR
OFF
LIFT
GROUND
EQ ON
EQ FS
CAUTION: Unplug
power before
servicing
120 V~
60 Hz
1 A
1.25 A
SLO
BLO
AMPLIFIER
44YV
HEADPHONERETURNSEND
4 OHM 8 OHM
4 OHM
REVERB
CH 2 CH 1
MARK FIVE: 25™
VACUUM TUBE
AMPLIFIER
HANDCRAFTED
IN PETALUMA,
CALIFORNIA
80Hz 240 750 2200 6600
25 W
10 W
25 W
10 W
TUBE GUIDE
6 x 12AX7
2 x EL 84
PATENTED
7,602,927
(USE WITH TWO 8 OHM SPKRS)
FX
SPEAKERS
INPUT
FT SW
POWER
STANDBY
MARK
5
TWENTY-FIVE
Page view 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 51 52

Comments to this Manuals

No comments